User Manual
Table Of Contents
- 1 About this document
- 2 Overview
- 3 Notes
- 4 Functions
- 4.1 Temperature control
- 4.2 Operating modes
- 4.3 Room temperature setpoints
- 4.4 Application overview
- 4.5 Power supply selection for RDG200KN
- 4.6 Additional functions
- 4.7 Control sequences
- 4.7.1 Sequence overview (setting via P001)
- 4.7.2 Application mode
- 4.7.3 2-pipe fan coil unit
- 4.7.4 2-pipe fan coil unit with electric heater
- 4.7.5 2-pipe fan coil unit with radiator or floor heating
- 4.7.6 2-pipe/2-stage heating or cooling
- 4.7.7 4-pipe fan coil unit
- 4.7.8 4-pipe fan coil unit with electric heater
- 4.7.9 Chilled/heated ceiling and radiator applications
- 4.7.10 Compressor applications
- 4.7.11 Applications with external AQR sensor or QMX room operator unit
- 4.7.12 Setpoints and sequences
- 4.8 Control outputs
- 4.9 Fan control
- 4.10 Multifunctional input, digital input
- 4.11 Handling system faults
- 4.12 KNX communications
- 4.13 Communication objects (S-Mode)
- 4.14 Communication objects (LTE-Mode)
- 4.15 Control parameters
- 5 Supported KNX tools
- 6 Connection
- 7 Technical data
- 8 Dimensions
- Index /
Supported KNX tools
ACS tool
5
A6V11545892_en--_a 121 | 150
1
Select Room relative humidity in the left pane to display humidity
parameters.
2
Adjust the parameters as needed. See Control parameters [➙ 108] for
more details on control parameters.
3
Select as group object in checkbox Humidity setpoints, to display the S-
Mode humidity setpoint in the Group Objects tab as follows:
4
Select Receive in checkbox Room relative humidity. The thermostat then
receives the room’s relative humidity from an external sensor.
5.2 ACS tool
The ACS tool is used to commission the RDG2..KN KNX room thermostats
(physical address, application, parameters). They can be operated or monitored by
bus during normal operation.
This section does not describe how to define the physical address and only
provides a brief overview of ACS main function.
For more information, refer to the ACS online help.
Setting RDG2..KN KNX parameters is only supported by ACS version 13.03 or
higher.
Humidity parameters
ACS
Note!