User Manual
Table Of Contents
- 1 About this document
- 2 Overview
- 3 Notes
- 4 Functions
- 4.1 Temperature control
- 4.2 Operating modes
- 4.3 Room temperature setpoints
- 4.4 Application overview
- 4.5 Power supply selection for RDG200KN
- 4.6 Additional functions
- 4.7 Control sequences
- 4.7.1 Sequence overview (setting via P001)
- 4.7.2 Application mode
- 4.7.3 2-pipe fan coil unit
- 4.7.4 2-pipe fan coil unit with electric heater
- 4.7.5 2-pipe fan coil unit with radiator or floor heating
- 4.7.6 2-pipe/2-stage heating or cooling
- 4.7.7 4-pipe fan coil unit
- 4.7.8 4-pipe fan coil unit with electric heater
- 4.7.9 Chilled/heated ceiling and radiator applications
- 4.7.10 Compressor applications
- 4.7.11 Applications with external AQR sensor or QMX room operator unit
- 4.7.12 Setpoints and sequences
- 4.8 Control outputs
- 4.9 Fan control
- 4.10 Multifunctional input, digital input
- 4.11 Handling system faults
- 4.12 KNX communications
- 4.13 Communication objects (S-Mode)
- 4.14 Communication objects (LTE-Mode)
- 4.15 Control parameters
- 5 Supported KNX tools
- 6 Connection
- 7 Technical data
- 8 Dimensions
- Index /
Functions
Communication objects (LTE
-
Mode)
4
A6V11545892_en--_a 107 | 150
4.14 Communication objects (LTE-Mode)
RDG
Geographical zone
A.R.S
Room operating mode:
Time switch
(Time switch zone)
X.1.1/X.Y.1
Application mode
Room operating mode:
Preselection
Geographical zone
A.R.S
X.Y.1
Room temperature
Comfort setpoint Room humidity [% r.h.]
Setpoint heating
Setpoint cooling
Fan speed
Setpoint shift heating
Setpoint shift cooling
Heat distr. zone
Heating coil energy
demand
heating coil
Heating/cooling
changeover
Ref. distr. zone
Cooling coil
Cooling coil energy
demand
Heating distr. zone
Heating surface
Energy demand heating
surface
Broadcast
Fault transmission Fault information
Fault text
Outside air temp. zone
Outside temperature
Fixed at 31