User Manual

18
Siemens
Datasheet
A6V11545853_en--_a
Smart Infrastructure
2020-09-07
Setpoint and range limitation
We recommended to review the setpoints and setpoint ranges (P011, P013…P016, P019,
P020) and change them as needed to achieve maximum comfort and save energy.
Programming mode
The programming mode helps to identify the thermostat in the KNX network during
commissioning.
Touch both the left and right buttons simultaneously for 6 seconds to activate programming
mode, which is indicated on the display with PROG.
Programming mode remains active until thermostat identification is complete.
Assign KNX device address
Assign device address (P900) via HMI, ACS, ETS or Siemens smartphone application PCT
Go for Android™.
Set the device address to 255, and then the communication is deactivated (no exchange of
process data).
Assign KNX group address
Use ETS to assign the KNX group addresses of the thermostat's communication objects.
KNX serial number
Each device has a unique KNX serial number at the rear.
An additional sticker with the same KNX serial number is enclosed in the package box. This
sticker is intended for documentation purposes of installers.
Disposal
The device is considered an electronic device for disposal in accordance
with the European Guidelines and may not be disposed of as domestic
garbage.
● Dispose of the device through channels provided for this purpose.
● Comply with all local and currently applicable laws and regulations.
Open Source Software (OSS)
All open source software components used within the product (including their copyright
holders and the license conditions) can be found from the website
http://www.siemens.com/download?A6V12046962.
Warranty
Technical data on specific applications are valid only together with Siemens products listed
under "Equipment combinations". Siemens rejects any and all warranties in the event that
third-party products are used.