Operating Instructions

22 A6V11439451_----_c
Firmware Setpoint Settings
Item Description Range Factory
settings
TCSP
Filter time
setting
0
…
9
999
8760
PM2.5
SP
PM2.5 setpoint SPML…SPMH 60
CO2 SP CO2 setpoint SPCL…SPCH 1000
T SP Temperature setpoint T SP L…T SP H 24
T SP H Temperature setpoint
range
high
Max. of low range…200 (°C) 50
T SP L Temperature setpoint
range
low
-50…Min. of high range (°C) 5
VOC SP VOC setpoint %: 0…100
mg/m
3
: 0…5
0.6 mg/m
3
or
6
%
HUM
SP
Humidity setpoint 0…100 % 50 %
P81
1)
Device address (KNX
only)
1…255 255
1)
P81 is only for ETS and local HMI does not support P81:
· During powering up, there is a startup delay (TwaitDevice = tWaitMin +
DeviceAdr * 200ms) before the processing signal is processed.
· When P81=255(default), the device does not process the signal
according to heartbeat and COV mechanism. But it can respond when
another device is polling.
· The local HMI does not support P81.
· When individual address is changed via ETS, P81 is updated
automatically after device downloads it from ETS.