User Manual

ManualsBrandsSiemens ManualsThermostats (temperature controller with sensor)Touchscreen Flush-mount Room Thermostats with KNX Communications, RDF800KN…, RDF800KN/VB

2 / 20

Siemens RDF800KN… CB1N3174en

Smart Infrastructure Touch Screen Flush-mount Room Thermostats with KNX Communications 2020-02-21

Use

Room temperature control (heating or cooling) in individual rooms and zones by

means of:

· 2-pipe fan coil units

· 2-pipe fan coil units with electrical heater

· 4-pipe fan coil units

· Chilled /heated ceiling

· Chilled /heated ceiling and electrical heater

· Chilled ceiling and radiator / under floor heating

· Compressors in DX-type equipment

· Compressors in DX-type equipment with electrical heater

The RDF800KN... controls:

· One single or 3-speed fan

· One or two ON/OFF valve actuators

· One ON/OFF valve actuator and one 1-stage electrical heater

· One 3-position valve actuator

· One 1-stage compressor in DX-type equipment, or one 1-stage compressor with

electrical heater

Used in systems with:

· Heating or cooling mode

· Automatic heating/cooling changeover

· Manual heating/cooling changeover

· Heating and cooling mode (such as 4-pipe system)

The room thermostats are delivered with a fixed set of applications. The relevant

application is selected and activated during commissioning using one of the

following tools:

· Synco ACS

· ETS5

· Local DIP switch and HMI

Functions

· Room temperature control via built-in temperature sensor or external room

temperature / return air temperature sensor

· Changeover between heating and cooling mode (automatically via local sensor

or bus, or manually)

· Selection of applications via DIP switches or commissioning tool

· Selection of operating mode via touch screen

· Temporary Comfort mode extension

· 1- or 3-speed fan control (automatically or manually)

· Display of current room temperature or setpoint in °C and/or °F

· Minimum and maximum limitation of room temperature setpoint

· Keylock function: unlock, total lock and setpoint

· 2 multifunctional inputs, freely selectable for:

- Window contact

- Presence detector

- External room temperature or return air temperature sensor

- Fault input

- Monitor input for temperature sensor or switch state

- Sensor for automatic heating / cooling changeover (RDF…)

- Dew point sensor (RDF…)

- Electric heater enable (RDF…)

· Advanced fan control function, such as: fan kick, fan start delay, and selectable

fan operation (enable, disable or depending on heating or cooling mode)