Data Sheet for Product

10 / 22
Siemens RDF800… A6V101123362_en--_d
Smart Infrastructure Touch screen flush-mount standalone room thermostats 2019-10-29
Setting parameters using the local HMI
Wake up the thermostat by touching the screen display.
Factory setting for the Service level password is 00 00.
1. Touch and hold down the icon for 5 seconds. Then set the first 2-digit
number to 00 using /.
2. Touch the last 2-digit number and set it to 00 using /.
3. After 3 seconds, P (successful login) or F (fail to login) is displayed.
4. If the login failed, reenter the correct password as per step 1 above. After
successful login, the first parameter is displayed as shown in the following
example:
• Touch any icon to exit.
• Touch / to select any parameter and +/– to adjust values.
• When reaching END, touch END to exit.
Follow the same steps for entering the Expert level.
Factory setting for Expert level password is 99 99.
After entering the correct password, the screen displays as follows. Touch / to
advance or return to the desired parameter and use +/- to select the desired
available value.
The factory setting for the control parameters can be reloaded using P71, by
setting the value to ON.
Entering the Service
level
Notes:
Entering the Expert
level
Configuring parameters
Resetting parameters