User Manual

6/16
Siemens Room Temperature Controllers N3067en
Building Technologies 2014-04-04
Auto Timer (only RDF410…)
The controller provides an Auto Timer mode with 8 programmable timers. In this mode,
the controller will automatically change over between Normal operation and Economy
(Energy saving) mode according to the preprogrammed timers.
Auto Timer during Normal operation Auto Timer during Economy (Energy saving) mode
AUTO
C
1
AUTO
C
1
Each timer has a Normal operation start time and a Normal operation end time which
can be applied to several weekdays.
To adjust the time schedule, keep the Prog button pressed for 3 seconds to go to the
programmable timer setting mode.
This mode is indicated by displaying Ax (x= auto timer 1...8) and the time xx:xx
flashing.
For each auto timer, proceed as follows:
1. The
and symbols are displayed. Press + or - to adjust the Normal operation
start time and confirm by pressing ok.
2. The and symbols are displayed. Press + or - to adjust the Normal operation
end time or Economy (Energy saving) start time respectively and confirm by
pressing ok.
Setting the timers