Technical data
Table Of Contents
- 1. About this document
- 2. Summary
- 3. Functions
- 3.1 Temperature control
- 3.2 Operating modes
- 3.3 Room temperature setpoints
- 3.4 Applications overview
- 3.5 Additional functions
- 3.6 Control sequences
- 3.7 Control outputs
- 3.8 Fan control
- 3.9 Multifunctional input, digital input
- 3.10 Handling faults
- 3.11 KNX communications
- 3.11.1 S-mode
- 3.11.2 LTE mode
- 3.11.3 Zone addressing in LTE mode (in conjunction with Synco)
- 3.11.4 Example of heating and cooling demand zone
- 3.11.5 Send heartbeat and receive timeout
- 3.11.6 Startup
- 3.11.7 Heating and cooling demand
- 3.11.8 Fault function on KNX
- 3.11.9 KNX switching groups (RDF301.50, RDF301.50H only)
- 3.12 Communication objects (S-mode)
- 3.13 Communication objects (LTE-mode)
- 3.14 Control parameters
- 4. Handling
- 5. Supported KNX tools
- 6. Connection
- 7. Mechanical design
- 8. Technical data
5. Supported KNX tools
5.1 ETS
ETS is an engineering tool. It can be used for the full commissioning of the RDF
KNX thermostats.
The following functions can be realized with ETS4:
– Define and download the physical address
– Define and download the application (plant type, control sequence)
– Set up and download the thermostat's control parameters
– Download the switching group parameters (RDF301.50)
– Set up and download group addresses.
This basic documentation does not describe how to operate ETS and commission
a device. Refer to the KNX Manual for more details.
Setting RDF KNX parameters is only supported by ETS4 or higher.
ETS4 can be updated online.
5.1.1 Parameter settings in ETS
For setting the parameters, open the project and select a device.
To start the parameter settings, select Edit, then Edit parameters.
• The ETS version 3f or higher can be used to assign the communication objects
to group addresses (S-mode).
• The ETS4 or higher can be used to download the application and parameters.
ETS
STOP
Note!
Note:
76 / 92
Siemens RDF301, RDF301.50..., RDF600KN Basic documentation CE1P3171en
Building Technologies Supported KNX tools 2014-05-23