User Manual

5
Smart Infrastructure
A6V11562464_en--_a
2019-09-19
● Choose the location to ensure largely interference-free reception. When mounting the
receiver, observe the following:
– Do not mount in a control panel
– Do not mount on metallic surfaces
– Do not mount near 2.4 GHz wireless electronic devices such as PCs, WiFi routers,
microwaves, etc.
– Do not mount near constructional elements with fine metal or large metallic
structures such as a distribution box
Wiring
● The AC 230 V mains supply line must have an external circuit breaker with a rated
current of no more than 10 A.
● Ensure that wiring, protection and earthing comply with local regulations.
● Adapt the line diameters as per local regulations to the rated value of the installed
overcurrent protection device.
● Disconnect from power supply before removing the unit from its mounting plate.
● Make sure the receiver is not connected to power during wiring.
Commissioning
LED indication on RCR114.1
RCR114.1 has one LED to indicate its status.
Device status
LED status
Idle Solid yellow
Connecting to RDS110.R Flashing green
Successful connection Solid green
Thread network works, but communication with RDS110.R
failed
1)
Flashing red
Thread network failure
2)
Solid red
Factory reset Alternating red and green
1. Reconnection is performed automatically or manually.
2. Reconnection can only be performed manually.
Manual network reconnection
1. Check whether RDS110.R is powered on and in normal operation.
2. If the reconnection still fails, delete RCR114.1 in the device list of RDS110.R, then long
press button
on RCR114.1 for 8 seconds and re-add RCR114.1 to the device list.