Data Sheet for Product

Notes
Installation Instructions are enclosed in the package.
It must be ensured that there is sufficient clearance above the thermostat for adjusting
the setpoint and for removing or replacing the thermostat, if required.
Mount the pocket and adjust the hexagon as required. Immerse the capillary sensing
element in the pocket and secure the base to the pocket by means of the screw.
Double pocket (ALT-DB..J) with the ending „J“ fits to this RAZ units only.
To prepare for wall mounting, knock out the fixing holes in the housing and pull out the
capillary tube until the required length is reached. After immersing the capillary sensing
elements in the pocket, secure it with a clamp (mounting accessories).
The internal limit temperature must be adjusted only by qualified personnel.
The appliance must be wired by the installer only.
The cables used must meet the insulation requirements for mains voltage.
Wire the thermostat according to the connection diagram and in compliance with local
regulations.
Caution: prior to opening the housing, disconnect the thermostat from the mains supply.
Earth connections must be made in compliance with the regulations.
Disposal
The devices are considered electronics devices for disposal in terms of European
Directive 2012/19/EU and may not be disposed of as domestic waste.
• Dispose of the device via the channels provided for this purpose.
• Comply with all local and currently applicable laws and regulations.
Mounting aid
Mounting location
Pocket mounting
Important
Wall mounting with
sensing element in
the
pocket
Temperature setting
Wiring
Max. AC 250 V
3/6
Siemens Control Thermostat / Thermal Reset Limit Thermostat RAZ-TW CE1N1212en
Building Technologies 2014-07-30