User Manual

Type summary
Product No. Stock number
Degree of
protection
Switch-off
temperature
Capillary
tube length
Scope of delivery
Pocket
length
1)
RAK-TB.1400S-M S55700-P108 IP43 45...60 °C
700 mm
Pocket (for RAK….B) /
Clamping band for max.
pipe dia. 100 mm /Cable
gland M16x1.5 mm /
Mounting instructions
---
RAK-TB.1410B-M S55700-P109 IP43 50...70 °C 100 mm
RAK-TB.1420S-M S55700-P110 IP43 65...80 °C ----
1) Pocket ALT-SB100, brass nickel-plated, PN10
Refer to Data Sheets N1193 and N1194.
When ordering, please give type reference according to “Type summary“ (standard
set).
If the accessories required are not those included in the standard set, they can be
ordered separately according to the type references given in Data Sheets N1193 and
N1194.
Mechanical design
• The base of the thermostat is made of PC (reinforced) and is designed for pipe,
pocket or wall mounting; the electromechanical thermal reset limit thermostat uses a
capillary type sensing element.
• The cover is made of PC and has a viewing window.
• The cable gland is M16x1.5 mm.
•
The PC plastic is especially designed to be flame resistant, UV protected and
flexible against high temperatures and tough against chemical and biological
impacts.
Notes
Installation Instructions are enclosed in the package.
It must be ensured that there is sufficient clearance above the thermostat for seeing
through the viewing window, for adjusting the switch-off temperature and for removing
and replacing the thermostat, if required.
The clamping band should be properly tightened to ensure the entire length of the
sensing element is in close contact with the pipe’s surface.
Mount the pocket and adjust the hexagon as required. Immerse the capillary sensing
element in the pocket and secure the base to the pocket by means of the screw.
To prepare for wall mounting, knock out the fixing holes in the housing and pull out the
capillary tube until the required length is reached. After immersing the capillary sensing
element in the pocket, secure it with a clamp (mounting accessories).
The switch-off temperature must be adjusted only by qualified personnel.
The appliance must be wired by the installer only.
The cables used must meet the insulation requirements for mains voltage.
Wire the thermostat according to the connection diagram and in compliance with local
regulations.
Caution: prior to opening the housing, disconnect the thermostat from the mains supply.
Earth connections must be made in compliance with the regulations.
Accessories
Ordering
Housing
Mounting aid
Mounting location
Pipe mounting
Pocket mounting
Wall mounting with
sensing element in the
pocket
Temperature setting
Wiring
Max. AC 250 V
2/4
Siemens Limit thermostats RAK-TB CE1N1206en
Building Technologies 2014-07-30