Installation Instructions

Document No. 129-433
Installation Instructions
February 18, 2016
Siemens Industry, Inc. Page 3 of 4
Installing Sensing Temperature
Elements (QPM2180 Only)
The QPM2180 is shipped with four sensing
elements: NTC 10K Ohm, Platinum 1000, Nickel
1000 and Platinum 100 (packaged separately).
Figure 5. Sensing Element Selections.
To install the sensing element of your choice, follow
the instructions depicted in Figure 6:
1. Remove the protective end cap.
2. Insert the element.
3. Using a small, flat-blade screwdriver, tighten
the sensor’s two mounting screws.
4. Replace the protective end cap.
Figure 6. Installing the Sensing Element.