Data Sheet for Product

14 / 16
QMX3... Wall-mounted sensors and room operator units for KNX PL-Link, KNX S-mode and KNX LTE-Mode CM2N1602en_08
Siemens Smart Infrastructure 2020-04-03
Display Type Segment LCD
Information displayed depends on the application in the
room automation station.
– Room temperature, humidity, CO
2
– Setpoint adjustment
– Control mode
– Manually selected fan speed
– Control sequence
– Scenes (LED next to the button)
– etc.
Ports/interfaces Type of port between room automation station and room
operator unit
KNX / PL-Link
Baud rate 9.6 kbps
Standard KNX plug Wire diameter0.8 mm, max. 1.0 mm
(solid conductors only)
Cable type Solid conductors 2-core, twisted pair
Single cable length (from room automation station to room
operator unit)
<1000 m
Cables must comply with KNX specifications, see TRA Install. manual, CM111043
*)
Housing protection Protection standard as per EN 60529 IP 30
Protection class Insulation protection class III
Ambient conditions IEC 721 Normal operation Transport
Environmental conditions Class 3K5 Class 2K3
Temperature 0...50 °C – 25...70 °C
Humidity < 85 % rh < 95 % rh
Mechanical conditions Class 3M2 Class 2M2
Standards and directives EU conformity (CE) CM2T1602xx
*)
compliance
UL916
compliance
Part 15 of the FCC rules
CSA compliance C22.2 No 205 – Signal equipment
C22.2 No 0 – General Requirements
RCM Mark conformity (EMC)
AS/NZS 61000-6-3
The product environmental declaration CM2E1602
*)
contains data on environmentally compatible product
design and assessments (RoHS compliance, materials composition, packaging, environmental benefit,
disposal)
Color
Front housing Models QMX3.Pxx
Models QMX3.Pxx-1BSC
Titanium white similar to RAL9010
Black similar to RAL9005
Weight [g] Q
MX3.
P02 P30 P34 P44 P37 P40 P70 P74
Operator unit 91 84 122 123 124 85 97 132
Base plate 20 20 20 20 20 20 20 20
Packaging 64 64 64 64 64 64 64 64
Total 175 168 206 207 208 169 181 216
*)
The documents can be downloaded from http://siemens.com/bt/download.
Notes on FCC rules
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTICE
FCC warning