Basic Documentation
Table Of Contents
- Wall-mounted sensors and room operator units for KNX/ETS and KNX/ACS
- Contents
- 0 About this document
- 1 Devices
- 2 Safety and EMC optimization
- 3 Mounting and electrical installation
- 4 Functionality / Use
- 5 ETS engineering
- 5.1 Engineering
- 5.2 Commissioning
- 5.3 Communication objects
- 5.4 Room operator unit visualization and operation
- 5.5 ETS parameter description
- 5.5.1 Room temperature sensor
- 5.5.2 Room temperature control
- 5.5.3 Room relative humidity sensor
- 5.5.4 Room relative humidity control
- 5.5.5 Room air quality sensor
- 5.5.6 Room air quality control
- 5.5.7 Device display parameters
- 5.5.8 HVAC operation and display
- 5.5.9 Operation and display: Relative humidity visualization
- 5.5.10 Display on QMX3.P70 Air quality indication LED
- 5.5.11 Operation and display: air quality
- 5.5.12 Operation of light, shading and scenes
- 5.6 Examples for the operation of touch keys and display elements
- 6 ACS engineering
5 / 46
Siemens Wall-mounted sensors and room operator units for KNX/ETS and KNX/ACS CM2N1602en_07
Smart Infrastructure About this document 2020-06-20
Before using our products, it is important that you read the documents supplied
with or ordered at the same time as the products (equipment, applications, tools
etc.) carefully and in full.
We assume that persons using our products and documents are authorized and
trained appropriately and have the technical knowledge required to use our
products as intended.
For more details on the products and applications, please refer to:
· On the internet: "Technical product data and descriptions" at
www.siemens.com/gamma-td
· On the intranet (for Siemens employees only) at
http://step.bt.siemens.com/portal/index.html
· At your next Siemens branch office www.siemens.com/sbt or at your system
suppliers.
· From the support team in the headquarters fieldsupport-
zug.ch.sbt@siemens.com if no local POC is available.
Siemens assumes no liability to the extent allowed under the law for any losses
resulting from a failure to comply with the aforementioned points or for the
improper compliance of the same.
0.3 Abbreviations and naming conventions
Abbr.
Description
ACS790
Engineering Tool for Synco devices
ETS
Engineering Tool S
oftware
http://www
.knx.or
g/
KNX/A
CS
Communication with KNX, configuration with ACS
KNX/ETS
Communication with KNX, configuration with
ETS
The term "room operator unit" in this document always refers to all types:
QMX3.P02. P30. P34, P70 und P74.
0.4 Reference documents
The following documents are available at www.siemens.com/gamma-td
[1] Data sheet N1602
[2] Mounting instructions M1602
[3] Word template for labels (QMX3.P02, P37) M1602.1
[4] KNX Standard, Volume 3: System Specifications, Part 7, Chapter 2: Data
Point Types (http://www.knx.org/)
[5] Service- and Operating software ACS790 (Data sheet N5649)
The following document is available at
https://www.downloads.siemens.com/download-
center/Download.aspx?pos=download&fct=getasset&id1=20285
[6] KNX Bus (data sheet CE1N3127)
Use of documents /
Request to the reader
Abbreviations
Naming convention