Basic Documentation
Table Of Contents
- Wall-mounted sensors and room operator units for KNX/ETS and KNX/ACS
- Contents
- 0 About this document
- 1 Devices
- 2 Safety and EMC optimization
- 3 Mounting and electrical installation
- 4 Functionality / Use
- 5 ETS engineering
- 5.1 Engineering
- 5.2 Commissioning
- 5.3 Communication objects
- 5.4 Room operator unit visualization and operation
- 5.5 ETS parameter description
- 5.5.1 Room temperature sensor
- 5.5.2 Room temperature control
- 5.5.3 Room relative humidity sensor
- 5.5.4 Room relative humidity control
- 5.5.5 Room air quality sensor
- 5.5.6 Room air quality control
- 5.5.7 Device display parameters
- 5.5.8 HVAC operation and display
- 5.5.9 Operation and display: Relative humidity visualization
- 5.5.10 Display on QMX3.P70 Air quality indication LED
- 5.5.11 Operation and display: air quality
- 5.5.12 Operation of light, shading and scenes
- 5.6 Examples for the operation of touch keys and display elements
- 6 ACS engineering
4 / 46
Siemens Wall-mounted sensors and room operator units for KNX/ETS and KNX/ACS CM2N1602en_07
Smart Infrastructure About this document 2020-06-20
0 About this document
0.1 Revision history
Revision Date Changes Section Pages
_07 2020-06-20 · Added QMX3.P44 Various Various
_06 2019-04-08 · Bus voltage failure 5.2 25
_05 2018-09-14 · Corrections/additions for V6.1
· Communication objects
All
5.3
—
26
_04 2017-03-10 · Corrections/additions for V6.1
· Added QMX3.P40
All —
_03 2016-03-15 · Corrections/additions for V6.0 All —
_02 2015-04 · Corrections for V5.1
· Deleted section 5.1
5.3 —
_01 2013-07 First edition — —
0.2 Before you start
The trademarks used in this document and their lawful owners are listed in the
table below. The use of trademarks is subject to international and domestic
provisions of the law.
Trademark(s)
Legal owner
KNX® KNX Association, B - 1831 Brussels-Diegem Belgium
http://www.knx.org/
All product names listed in the table are registered (®) or not registered (™)
trademarks of the owner listed in the table. These trademarks will not be indicated
elsewhere in the text (e.g. by use of symbols such as ® and ™) due to the
reference in this Section and to facilitate the reading of the text,
This document may be duplicated and distributed only with the express permission
of Siemens, and may be passed only to authorized persons or companies with the
required technical knowledge.
These documents were prepared with great care.
· The contents of all documents are checked at regular intervals.
· All necessary corrections are included in subsequent versions.
· Documents are automatically amended as a consequence of modifications and
corrections to the products described.
Please make sure that you are aware of the latest document revision date.
If you find any lack of clarity while using this document, or if you have any
criticisms or suggestions, please contact your local POC at the nearest branch
office. Addresses for Siemens RCs are available at www.siemens.com/sbt
Trademarks
Copyright
Quality assurance