User Guide

Appendix A
5
39
Siemens Industry, Inc.
A6V11544782
02/22/2019
SNMP Object Definitions – MIB File
Object Identifier
Description
STATUS
Array containing the below info
COMM_CHANNEL
Communication channel of system
COMM_NET_ID
Communication network ID of system
ACTIVE_SENSORS
Number of sensors active in system
SENSORS_WITH_LOW_BATTERY
Number of sensors that are sending a low battery signal
REPEATER_MODE
“1” means gateway is set as a repeater
TIMEOUT_CONFIG
Value (minutes) of timeout setting; mode disabled if “0”
SENSORS_IN_TIMEOUT
Number of sensors currently in timeout, if mode enabled
SOFTWARE_VERSION
Version of gateway software
Data Arrays
PWR
Battery voltage, or RSSI of RF powered sensors
DELTA_T
Time (seconds) since the last packet was received
S1
Sensor input 1
S2
Sensor input 2
S3
Sensor input 3
S4
Sensor input 4
S5
Sensor input 5
S6
Sensor input 6
S7
Sensor input 7
S8
Sensor input 8
TXID
Transmitter ID (only valid in RF powered sensors)
NOTE:
Each data array contains points, all labeled “node_XXX” where XXX is a number from
001 to 100, representing every sensor available in the system. All array points are
available regardless of whether or not they are active in the system. Each data array is
configured for up to 8 sensor inputs per device.
XML Configuration
A gateway with XML configured as the output can be accessed using HTTP-GET and
HTTP-POST commands. Using this method, the data arrays in the Processor unit are
accessed directly. The following table identifies the arrays and the information
contained within.