User Guide

3
Gateway Configuration
Configuring and Associating a Wireless Sensor Node to a Gateway
24
Siemens Industry, Inc.
A6V11544782
02/22/2019
The sensor descriptions shown on the screen will be different than the Siemens Series
4292 part numbers. A cross reference is as follows:
Description Shown inTera Term
Siemens Part Number
Description
58-N-1201-TX-N
QAA4292.EWSC
Temperature Sensor with
2 Remote 10k Ohm Type
2 Thermistor Inputs
58-N-1201-TH-N
QFA4292.EWSC
Temperature/Humidity/
Dew Point Sensor
58-N-1202-CO2-R
QPA4292.EWSC
CO
2
Sensor
58-N-1201-C-N
563-083
Contact Closure
Transmitter with 2 Inputs
Sensor descriptions may be changed by using Option M-4 Manually Activate or
Deactivate Sensors.
The message below is displayed when the connected sensor has a Sensor ID that is
already configured in the gateway. When this occurs, additional options are provided
as shown.
Click the corresponding number to perform the action described.
Option 1 will reconfigure the sensor with the next Sensor ID available in the system. Do
this when adding a sensor to a network that was already part of a different network, but
was not erased from the previous gateway.
Option 2 will erase all configuration data from the sensor.
Option 3 will erase all configuration data from the sensor and remove it from the
gateway.
Option 4 will update the sensor to match the gateway’s communication configuration.
NOTE 1:
This option is only available if the configuration data of the sensor and gateway is
different.
NOTE 2:
If a configuration error occurs due to a faulty connection of the USB port/cable such as
electrical noise, the system may display some unknown data but will conclude with a