User Guide

2
Software Installation and Commissioning
Installation and Configuration of Tera Term
14
Siemens Industry, Inc.
A6V11544782
02/22/2019
NOTE:
The driver only needs to be located and installed once. After the initial installation, if
you connect a new gateway to the same computer, you can have Windows
automatically find the correct driver without locating it manually.
Installation and Configuration of Tera Term
Tera Term or an equivalent terminal emulator program is needed to display data from
the gateway and for configuration of certain parameters. For Windows XP and earlier
versions you may also use HyperTerminal which is included with Windows (no
installation is required).
Within the Siemens network, Tera Terminal can be installled from the Install Software
section of the UCMS Control Center.
Outside the Siemens network, Tera Terminal can be downloaded here.
(https://osdn.net/projects/ttssh2/downloads/70355/teraterm-4.101.zip/)
Save the files to a location of your choice. Do not launch Tera Term until after the USB
driver has been installed. These instructions describe how to configure Tera Term, but
the following settings are needed with any terminal emulator that is used:
Baud rate: 19200 bps
Data bits: 8 bits
Parity: None
Stop bits: 1 bit
Flow control: None
Emulation: ANSI or Auto Detect