Basic Documentation

About this document
Revision history
1
A6V12297475_en--_a
3 | 14
1 About this document
1.1 Revision history
Edition
Date
Changes
Section
a
2021-01
First version.
All
1.2 Before you start
This document may be duplicated and distributed only with the expressed
permission of Siemens Switzerland Ltd.
These documents were prepared with great care.
● The content of all documents is checked at regular intervals.
● All necessary corrections are included in subsequent versions.
● Documents are automatically amended as a consequence of modifications and
corrections to the products described.
Please ensure that you have the latest document revision.
If you have any questions or suggestions about this document, or if you have any
criticisms or suggestions, please contact your local point of contact (POC) at the
nearest branch office. Addresses for Siemens RCs are available at
www.siemens.com/sbt.
Markups
Special markups are indicated in the document as follows:
●
Numbered lists and instructions with an operation sequence
1.
2.
Procedures must be performed in the specified order.
[➙ X]
Reference to a page number
Symbol identifications
WARNING
This is the symbol for hazard. It warns you of Risks of injury. Comply with all
measures designated by this symbol to prevent injury or death.
NOTICE
This symbol identifies an important notice that you should be aware of when you
are using the product.
Before using products from Siemens Switzerland Ltd., it is important that you
carefully read the documents supplied with or ordered at the same time as the
products (equipment, applications, tools, and so on).
We assume that users are authorized and trained appropriately and have the
technical knowledge required to use our products as intended.
Additional information on products and applications is available:
Copyright
Quality assurance
Conventions for text
marking
Document use/ request
to the reader