Commissioning Instructions

81 / 134
Siemens Synco™ living CE1C2740en
Building Technologies Commissioning the system 13.12.2010
Connect output for cooling enable
Inform the central apartment unit that you want to connect a cooling enable
output:
Main menu > Commissioning > RF connections
> Outputs > Cooling enable > Connect device:
The following device channels can be connected:
• Universal relay output Qx of a heating circuit controller (see page 62).
• Universal relay
output Qx of a multi-controller (see page 65).
Connect the window/door state output
Inform the central apartment unit that you want to connect a window/door out-
put:
Main menu > Commissioning > RF connections
> Outputs > Window/door state > Connect device:
The following device channels can be connected:
• Universal relay output Qx of a heating circuit controller (see page 62).
• Universal relay
output Qx of a multi-controller (see page 65).
Connect Hager tebis devices (QAX913 only)
Hager tebis lighting and blinds actuators can only be assigned to
switching groups or lamps set up for the respective function.
(See pages 29 and 35.)
The lighting and
blinds actuators are switched on
as soon as power is applied.
Hager tebis devices are commissioned and connected to the central apart-
ment unit with the help of the TX100 configurator from Hager. To connect or
remove Hager tebis products, select the following menu on the central apart-
ment unit:
Main menu > Commissioning > RF connections > Hager Tebis
Always use this menu when working with the TX100 configurator. Exit
the "Hager tebis" menu only when configuration with the TX100 is
completed. If you exit and reselect the "Hager tebis" menu while work-
ing with the TX100 configurator, the configurator’s operating mode
must briefly be switched to "Auto" and back to "Prog".
Numbering inputs
Switching groups are inputs from the configuration device TX100 perspective.
To provide these inputs to the configurator and to assign a number, select the
respective switching group on the central apartment unit and press the
Menu/ok button: