Manualshelf

User Manual

ManualsBrandsSiemens ManualsHome Automation SystemsSynco living Central apartment unit QAX910
71727374757677787980
77 / 100
Siemens Synco™ living Operating instructions CE1B2707en
Building Technologies Central apartment unit QAX910 23.08.2008
Main menu > Settings > Faults > Fault input X > Fault text:
Main menu > Settings > Faults > Fault input X > Fault priority:
Main menu > Settings > Faults > Fault input X > Fault release:
Main menu > Settings > Faults > Fault input X > Fault stat mess dly:
Main menu > Settings > Faults > Fault input X > Normal position:
Fault input 1 2 3 4
FS fault text Fault inp1 Fault inp2 Fault inp3 Fault inp4
Fault text
FS fault priority Not urgent Not urgent Not urgent Not urgent
Fault priority Urgent
N. urg.
Urgent
N. urg.
Urgent
N. urg.
Urgent
N. urg.
FS fault release Always Always Always Always
Fault release Always
DA
Always
DA
Always
DA
Always
DA
FS fault stat mess dly. 00.05 00.05 00.05 00.05
Fault status message delay
FS normal position Open Open Open Open
Normal position Open
Closed
Open
Closed
Open
Closed
Open
Closed
Fault input 5 6 7 8
FS fault text Fault inp5 Fault inp6 Fault inp7 Fault inp8
Fault text
FS fault priority Not urgent Not urgent Not urgent Not urgent
Fault priority Urgent
N. urg.
Urgent
N. urg.
Urgent
N. urg.
Urgent
N. urg.
FS fault release Always Always Always Always
Fault release Always
DA
Always
DA
Always
DA
Always
DA
FS fault stat mess dly. 00.05 00.05 00.05 00.05
Fault status message delay
FS normal position Open Open Open Open
Normal position Open
Closed
Open
Closed
Open
Closed
Open
Closed
FS Factory setting
N. urg. Not urgent
DA During absence
Fault outputs 1 and 2
To forward fault status messages or to indicate them on the control panel with
a lamp, for instance, 2 fault outputs can be configured.
The fault outputs must have been activated when commissioning the
plant, and the required relay output must be connected to the central
apartment unit so that the settings described here can be made. For
the relevant descriptions, refer to document ”Mounting and Commis-
sioning (CE1C2707en)“.
Main menu > Settings > Faults > Fault output X > Fault priority:
Main menu > Settings > Faults > Fault output X > Fault source: