User Manual

76 / 124
Siemens Synco™ living CE1C2707en
Building Technologies Commissioning the system 23.08.2008
Connect Hager tebis devices
Hager tebis lighting and blinds actuators can only be assigned to
switching groups or lights which, beforehand, were set up for the re-
spective function (refer to ”Configure the switching groups“ on page 32
and “Con
figure light status indication“ on page 35).
The lighting and
blinds actuators are switched on as soon as power is applied
to them.
Hager tebis devices are commissioned and connected to the central apart-
ment unit with the help of the TX100 configurator supplied by Hager. To be
able to make connections to Hager tebis products, or to remove them, select
the following menu on the central apartment unit:
Main menu > Commissioning > RF connections > Hager Tebis
This menu must always be used when working with the TX100 con-
figurator. Quit the "Hager tebis" menu only when configuration with the
TX100 is completed. If you leave the "Hager tebis" menu while working
with the TX100 configurator and you select it again, the configurator’s
operating mode must briefly be switched to "Auto" and then back to
"Prog".
Number inputs
From the configurator’s perspective, switching groups are inputs. To make the
configurator familiar with these inputs and to assign a number, select the
respective switching group on the central apartment unit and press the
Menu/ok button:
Main menu > Commissioning > RF connections
> Hager Tebis > Switching groups > Switching group X
Successful dispatch of the respective telegrams is displayed for a short mo-
ment on the central apartment unit.
For detailed information on commissioning Hager tebis components,
refer to the documentation covering Hager tebis products.
Connect RF repeaters
You can connect up to 3 RF repeaters.
To enable an RF repeater (1…3) to be connected, it must previously
have been activated in the basic configuration (refer to page 45).
An RF re
peater is automatically switched on as soon as power is applied via
the AC adapter, which is included in the scope of supply.
The LED lights up green for 2 seconds.
In the case of an RF repeater that is already connected, the LED extinguishes
afterwards. The repeater is now ready for operation.
But if the RF repeater is not yet connected, the LED starts flashing green. The
repeater is now ready for making the connection.