User Manual

68 / 124
Siemens Synco™ living CE1C2707en
Building Technologies Commissioning the system 23.08.2008
Connect GAMMA wave actuator
Press the button on the GAMMA wave actuator until the LED on the actuator
starts blinking (approx. 10 seconds). A successful connection appears on the
display of the central apartment unit and is confirmed with a beep. The LED
on the actuator extinguishes again.
You can connect all actuators of the same switching group, one after
the other, without having to make further entries on the central apart-
ment unit.
A switching group can be assigned any number of light actuators since
they are not entered on the device list of the central apartment unit.
When all light actuators of a switching group are connected, close the binding
process by pressing the Menu/ok button.
The process is required for every switching group.
For detailed information on commissioning GAMMA wave compo-
nents, refer to the documentation covering the GAMMA wave prod-
ucts.
Connect the switching group relay
Inform the central apartment unit that you want to use a universal relay output
Qx of a heating circuit controller or multi-controller as a switching group relay:
Main menu > Commissioning > RF connections > Switching group relay
> Switching group X > Connect device:
Confirm subentry “Connect device“ by pressing the Menu/ok button. To make
the connection, you are prompted to press the binding button on the device to
be connected.
Select a universal relay output Qx with the channel selection button (CH) on
the heating circuit controller or multi-controller. The LED of the selected chan-
nel blinks. If the selected channel is not yet connected, the binding LED
flashes.
Now, press the binding button on the heating circuit controller or multi-
controller. The LED lights up green. When it starts blinking, you can release
the binding button.
A successful connection appears on the display of the central apartment unit
and is confirmed with a beep. Close the binding process by pressing the
Menu/ok button.
Connect door contacts
Inform the central apartment unit that a door / window contact wave AP 260 is
to be connected as door contact:
Main menu > Commissioning > RF connections
> Doors > Door X (1 - 2) > Connect device: