User Manual

53 / 124
Siemens Synco™ living CE1C2707en
Building Technologies Commissioning the system 23.08.2008
Connect QAW910 room unit
The room unit is automatically switched on as soon as the batteries are in-
serted.
When the room unit is switched on,
the full display appears for 2 seconds.
If the batteries are close to exhaustion,
exhaustion, the low-battery symbol
appears.
As long as the room unit is not con-
nected, the display shows the binding
symbol and the room temperature.
A room unit which had previously been connected changes directly to
normal operation after the full display.
F
2707Z033
Now, keep multifunction button F
on the room unit depressed until
the binding symbol starts blink-
ing. Then, release the button
again.
F = multifunction button
Now, the binding symbol on the display of the room unit blinks and extin-
guishes on successful completion of the binding process with the central
apartment unit.
To confirm the successful connection, the central apartment unit delivers a
beep. When all devises of the room are connected, close the binding process
by pressing the Menu/ok button.
After a successful connection, the room unit makes a restart and changes to
normal operation. The binding symbol on the display extinguishes.
If the binding process with the central apartment unit proved unsuc-
cessful, the room unit switches to the display of the unbound state
after 1 minute.