User Manual

38 / 124
Siemens Synco™ living CE1C2707en
Building Technologies Commissioning the system 23.08.2008
Fault input Factory setting Your setting
1 ---  ---
 Via RF / S-Mode
 B (local)
2 ---  ---
 Via RF / S-Mode
 B (local)
3 ---  ---
 Via RF / S-Mode
 B (local)
4 ---  ---
 Via RF / S-Mode
 B (local)
5 ---
 ---
 Via RF / S-Mode
 B (local)
6 ---
 ---
 Via RF / S-Mode
 B (local)
7 ---
 ---
 Via RF / S-Mode
 B (local)
8 ---
 ---
 Via RF / S-Mode
 B (local)
Fault outputs 1 and 2
If system faults occur, they can be forwarded to an external component by
closing a fault output.
You can select the fault priority and origin of fault for the relay to close. For a
description of these settings, refer to the Operating Instructions, section
“Faults“.
State whether a fault output is used and how it should be controlled.
--- Inactive – fault output not required
Via RF Relay output Qx of an RRV91… heating
circuit controller or RRV934 multi-controller
used as a fault output
Q1 (local) Relay output Q1 of the central apartment
unit used as a fault output
Main menu > Commissioning > Basic configuration
> Faults > Fault output X:
Fault output Factory setting Your setting
1 ---  --- (none)
 Via RF
 Q1 (local)
2 ---  --- (none)
 Via RF
 Q1 (local)