User Manual

16 / 124
Siemens Synco™ living CE1C2707en
Building Technologies Commissioning the system 23.08.2008
Commissioning the system
Prerequisites
Prior to commissioning the system, check to ensure that the following prereq-
uisites are met:
• You are familiar with the different operating elements and operating levels
of the central apartment unit.
• All system components are correctly installed.
• Mains-powered components are connected to power.
• New batteries are readily available to be inserted in the battery-powered
devices *.
• Wired devices are connected to the KNX TP1 data bus.
* To extend battery life, insert the batteries only just before connecting
the device to the central apartment unit (for procedure, refer to the
Mounting Instructions of the relevant device).
Procedure
The system should be commissioned in steps:
1. Make the basic configuration of the central apartment unit.
2. Make the extra configuration of the central apartment unit.
3. Switch on and connect the devices communicating via radio (KNX RF).
4. Make the wiring test.
5. Configure the wired bus communication (KNX TP1).
6. Set the parameters of the central apartment unit.
Basic configuration of the central
apartment unit
To connect the devices, the basic configuration of the central apartment unit
must be made first.
Switch on the central apartment unit
To be able to make the basic configuration of the central apartment unit, it
must be switched on.
The unit switches on as soon as
power is supplied. During the period
of time the hour glass is displayed, a
short function test is made.