User Manual

110 / 124
Siemens Synco™ living CE1C2707en
Building Technologies Function settings 23.08.2008
Inputs / outputs
Simulation of outside temperature
For test purposes, outside temperatures of between -50 and 50 °C can be
simulated on the central apartment unit. In that case, the measured value of
the outside sensor is overridden. The simulated outside temperature is also
used for the composite and the attenuated outside temperature.
During the time simulation is active, fault status message “Outside tempera-
ture simulation active“ is displayed. Simulation must be manually reset
(setting ---).
The simulated outside temperature is only used locally.
The measured value of the connected outside sensor is forwarded to
other controllers on the same bus.
Main menu > Inputs/outputs > Inputs > OT simulation:
Factory setting --- (no simulation)
Your setting
Texts
The texts for “Plant name“, “Rooms“, “Switching groups, “Doors“, “Light status“
and “Temperatures“ can be entered on the service level and, for this reason,
are described in the Operating Instructions.
File name
A data set can be created with the ACS service tool and copied to the central
apartment unit. In that case, the file name of the data set appears on the
following menu line:
Main menu > Settings > Texts > File name:
Room group names 1 - 2
Assign telling names to the room groups (e.g. living space, adjoining rooms,
etc.).
Main menu > Settings > Texts > Room groups > Room group X:
Room group Factory setting Your setting
1 Room group 1
……………………………..
2 Room group 2
……………………………..