User Manual
101 / 110
Siemens Synco™ living CE1B2740en
Building Technologies Service 13.12.2010
Door/window contact wave AP 260 and DELTA reflex
smoke detector
The mounting and operating instructions for the DELTA reflex smoke detector
as well as the door/window contact wave describe how to change batteries.
Binding tests
Briefly press the function button (located under the battery compartment
cover) to trigger binding tests on the individual devices. Press simultaneously
the two upper buttons on the handheld control.
On the central apartment unit, every successful binding test is confirmed by 3
short acoustic signals. Also, the display shows an additional window with in-
formation about the test just made.
The additional window remains open until confirmed with the Menu/ok button
or the Esc button, or until replaced by the new additional window next time the
binding test is made.
During the binding tests, the LED on the individual devices is used to indicate
battery charge or, in the case of the radio repeater, to indicate mains voltage
(see page 96).
Binding tests can be triggered on the following types of devices: Room
unit, room temperature sensor, meteo sensor, radio repeater, radiator
control actuator, heating circuit controller, multi-controller, consumption
data interface, water detector, and handheld control.
After the binding test, the radio repeater indicates telegram traffic with
an orange LED blinking for 2 hours.
Function button on the room unit, room sensor,
meteo sensor, radio repeater, water detector and
radiator control actuator
Room unit QAW910 Radiator control actua-
tor SSA955
Room temperature sen-
sor QAA910,
meteo sensor QAC910,
radio repeater ERF910,
water detector QFP910
F
2707Z020
+
2707Z019
F
LED
F
LED
2707Z18
F = Function button
LED = Light emitting diode