User Manual

87 / 134
Siemens Synco™ living CE1C2740en
Building Technologies Commissioning the system 13.12.2010
Main menu > Commissioning > RF connections
> RF repeater > Other RF devices > Disconnect device:
You are prompted to press the binding button on the device to be discon-
nected. The action required on the device is the same as that required for
connecting.
Successful disconnection is displayed on the central apartment unit and con-
firmed with a beep. Close the disconnection process by pressing the
Menu/ok
button.
Replace devices
Inform the central apartment unit that you want to replace a meter via function
"Replace device". You do not need to disconnect and reconnect the corre-
sponding channel for the consumption data interface WRI982.
Function “Replace device“ is available in the same menu as the function
”Connect device“ of a meter:
Main menu > Commissioning > RF connections
> Meter > … > Replace device:
Submenu "Replace device" contains the settings needed to replace the meter
depending on the type of meter.
Replace meter on pulse input
If the meter you want to replace is connected to pulse input Px of the con-
sumption data interface WRI982, check and possibly enter the following set-
tings (see page 54):
Main menu > Commissioning > RF connections
> Meter > … > Replace device > Ident number:
Main menu > Commissioning > RF connections
> Meter > … > Replace device > Impulse sensor type:
Main menu > Commissioning > RF connections
> Meter > … > Replace device > Unit factor:
Main menu > Commissioning > RF connections
> Meter > … > Replace device > P'valency num:
Main menu > Commissioning > RF connections
> Meter > … > Replace device > P'valency denom:
Main menu > Commissioning > RF connections
> Meter > … > Replace device > Start value:
Adjusting one of the above variables is interpreted as change of meter
and registered accordingly in the central apartment unit. All current
values, due date values, monthly values of this meter are deleted and
invalidated in the central apartment unit. The change of meter is also
noted on the billing file.
Adjusting the pulse sensor type is not recorded as change of meter.