User Manual

ManualsBrandsSiemens ManualsSensors TemperatureCable temperature sensor QAP1030/UFH

CM1N1854en

2017-05-22

Building Technologies

Cable temperature

sensor

QAP1030/UFH

Use

The cable temperature sensor is used in electrical floor heating systems to monitor and

limit the floor temperature.

Owing to its insulation, the sensor is especially suited for use with controllers or room

thermostats whose sensor signal inputs are not galvanically separated from the

AC 230 V mains network.

Type summary

Product No. Description

QAP1030/UFH Cable temperature sensor with ferrules, cable length approx. 4 m

Ordering and delivery

When ordering, please indicate product No., order number and description:

Product No. Order number Description

QAP1030/UFH

S55720-S289 Cable temperature sensor

Summary of content (4 pages)

PAGE 1
Cable temperature sensor 854 QAP1030/UFH Use The cable temperature sensor is used in electrical floor heating systems to monitor and limit the floor temperature. Owing to its insulation, the sensor is especially suited for use with controllers or room thermostats whose sensor signal inputs are not galvanically separated from the AC 230 V mains network. Type summary Product No. Description QAP1030/UFH Cable temperature sensor with ferrules, cable length approx.
PAGE 2
Technical design The QAP1030/UFH acquires the floor temperature via its NTC 3k sensing element. The element’s resistance value changes depending on the temperature it acquires. It is available for further handling by a suitable controller or room thermostat. Mechanical design The sensor consists of a 2-wire cable of approximately 4 m length with ferrules and an NTC 3k sensing element.
PAGE 3
Disposal notes The device is considered an electronics device for disposal in terms of European Directive 2012/19/EU and may not be disposed of as domestic garbage. · Dispose of the device via the channels provided for this purpose. · Comply with all local and currently applicable laws and regulations. Technical data Function data Measuring range - 20...70 °C 1) Sensing element NTC (3 kW at 25 °C) Time constant in static air 1.5 min Measuring accuracy at 25 °C ± 0.
PAGE 4
Dimensions (in mm) QAP1030/UFH 4000+30 20 20 Published by: Siemens Switzerland Ltd. Building Technologies Division International Headquarters Gubelstrasse 22 6301 Zug Switzerland Tel. +41 41-724 24 24 www.siemens.com/buildingtechnologies 1854Z01 7.