Data Sheet for Product

3/8
Siem ens Immersion temperature sensors QAE21… CE1N1781en
Building Technologies 2018-05-28
Characteristic Accuracy
R Resistance value in Ohm
J Temperature in degrees Celsius
DJ Temperature differential in Kelvin
Mechanical design
The immersion temperature sensors consist of the following components:
· Two-sectional plastic housing comprised of base with connection terminals and re-
movable cover (snap-on design)
· Immersion rod complete with sensing element
The connection terminals can be accessed after removing the cover. The cable entry is
via a grommet which, if required, can be replaced by a cable entry gland M16 (IP54).
Accessories (not included in standard delivery)
Name Material Nominal
pressure
Type of sealing Immersion
length
Type
reference
Compression fitting V4A (1.4571) PN 16 Threaded with sealing means --- AQE2102
Protection pocket Brass (CuZn37) PN 10 Threaded with sealing means 100 mm ALT-SB100
Protection pocket Brass (CuZn37) PN 10 Threaded with sealing means 150 mm ALT-SB150
Protection pocket V4A (1.4571) PN 16 Threaded with sealing means 100 mm ALT-SS100
Protection pocket V4A (1.4571) PN 16 Threaded with sealing means 150 mm ALT-SS150
Protection pocket V4A (1.4571) PN 40 With flange for flat seal 100 mm ALT-SSF100
Protection pocket V4A (1.4571) PN 40 With flange for flat seal 150 mm ALT-SSF150
For other protection pocket accessories, refer to Data Sheet N1194.
Engineering notes
Protection pockets made of Brass may not be used with nominal pressures over PN 10
or at temperatures over 130° C. For higher nominal pressures or temperatures up to
max. 135 °C the protection pocker is to omit (max. PN 16) or a protection pocket made
of stainless steel (V4A) is required (see table accessories).
The max. media temperature for the QAE2130.xx is 125 °C!
NTC 10k
Legend