Installation Instructions

ManualsBrandsSiemens ManualsSensors Air qualityPL-Link Semi-Flush Mount Room Sensor Kits for Use with Siemens DXR Controllers Technical Specification Sheet

Document No. 129-805

April 1, 2016

Link Semi

Flush

Mount Room Sensor Kits

Page 1 of 3

Product Description

Siemens PL-Link Semi-Flush Mount Room Sensors

measure and transmit room temperature, humidity,

and CO2 data to a DXR Controller.

Sensors are offered as kits consisting of a base

module, front module and trim frame. Individual

components are also available as replacement

parts.

NOTE: These sensors are designed for installation

in a vertical 2” × 4” electrical box. Other

installation types are not recommended.

Expected Installation Time

25 minutes

Required Tools

· ABT Site or ABT Pro

· OCI702 KNX to USB interface (order

Siemens Part Number S55800-Y101)

· Small Phillips screwdriver

· Small flat-blade screwdriver

· (2) No. 6 × 1-1/4 Phillips panhead screws for

mounting to electrical box

Figure 1. Semi-Flush Mount Room Sensor.

Prerequisites

· Review these instructions before beginning.

· Ensure that appropriate field wiring is

installed in accordance with KNX standards.

NOTE:

All wiring must comply with applicable

building codes and regulations.

Product Numbers

Kit Part Number and Components

Measured Values

Kit Number

Base

odule

Front

odule

Frame

Temp

QAA2570.2532 AQR2570NJ AQR2532NNW AQR2510NGW N/A N/A

•

QFA2570.2535 AQR2570NJ AQR2535NNW AQR2510NGW N/A

• •

QPA2576.2535 AQR2576NJ AQR2535NNW AQR2510NGW

• • •

Summary of content (3 pages)

PAGE 1
Installation Instructions Document No. 129-805 April 1, 2016 PL-Link Semi-Flush-Mount Room Sensor Kits Product Description Siemens PL-Link Semi-Flush Mount Room Sensors measure and transmit room temperature, humidity, and CO2 data to a DXR Controller. Sensors are offered as kits consisting of a base module, front module and trim frame. Individual components are also available as replacement parts. NOTE: These sensors are designed for installation in a vertical 2” × 4” electrical box.
PAGE 2
Document No. 129-805 Installation Instructions April 1, 2016 Mounting and Electrical Installation Mounting Location • Locate sensor approximately 5 feet (1.5 m) above floor level and at least 1.75 feet (50 cm) from adjoining walls. • Do not install on outside wall, behind curtains, near heating/cooling sources, or where exposed to direct sunlight. Installation Procedure 1. Install base module (A) in the electrical box and use the No. 6 × 1-1/4 screws (provided) to attach the mounting plate (B) to the box.
PAGE 3
Document No. 129-805 Installation Instructions April 1, 2015 LED Indication Off Single orange flash Meaning Device is not connected to power, or device is powered and is working as intended. Feedback when pressing button > 2 seconds. 4. The Design Engineer sends the Pack & Go file to the Electrical Installer. 5. The Electrical Installer uploads this file into the automation station and runs initial tests using the SSA tool. Continuous orange flash Connection test or reset to factory default in process.