Installation Instructions

Document No. 129-485

November 2, 2015

Wireless TEC Room Temperature Sensor (Mesh)

Item Number 129-485, Rev. EA Page 1 of 3

Figure 1. Wireless Room Temperature Sensor.

Product Description

The APOGEE

Wireless Room Temperature

Sensors eliminate the need to run wire between the

Terminal Equipment Controllers (TECs) and their

respective room temperature sensor. The sensors

communicate with the Field Level Network

Transceivers (FLNXs), mounted at the TECs, that

also support the Wireless Field Level Network

(WFLN) Version 2.

Product Numbers

QAA2290.EWSC Sensing only*

QAA2290.DWSC Sensing with temperature

display *

QAA2290.FWSC Sensing with override,

setpoint, and temperature

display*

* NOTE: Field selectable Fahrenheit or Celsius.

Accessories

544-643A RTS passkey (to change display to

DIAG mode)

N/A Replacement 3.6 Volts lithium AA

battery –SAFT part number

LS14500BA (see Field Purchasing

Guide)

540-143 Laptop computer cable

(RJ-11 to DB-9)

141-570 Lockable Thermostat Guard

vented, clear plastic

PAGE 1
Installation Instructions Document No. 129-485 November 2, 2015 Wireless TEC Room Temperature Sensor (Mesh) Wireless Field Level Network (WFLN) 563-054 Field Level Network Transceiver (FLNX) Field Panel Transceiver (FPX) Wireless Transceiver Tool (TLX) 563-055 563-056 Expected Installation Time 10 minutes Figure 1. Wireless Room Temperature Sensor.
PAGE 2
Document No. 129-485 Installation Instructions November 2, 2015 WRTS Installation 1. 5. Select a location for the WRTS, following the standard rules for room temperature sensor placement. Locate the WRTS no further than 100 feet from the nearest FLNX on its WFLN, ideally in a location where there are no major RF obstructions (for example, metal or concrete walls) between the two. Always mount the sensor vertically. Locate the sensor as follows: • Per design specifications, and local regulations.
PAGE 3
Document No. 129-485 Installation Instructions November 2, 2015 Section 7.1.5 of RSS-GEN Operation is subject to the following two conditions: 1. this device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation. FCC NOTE: This device complies with Part 15 of the FCC rules.