Installation Instructions

Document No. 129-501
Installation Instructions
October 6, 2009
Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and
models as design improvements are introduced. Product or company names mentioned herein may be the trademarks of their respective
owners. © 2009 Siemens Industry, Inc.
Siemens Industry, Inc.
Building Technologies Division
1000 Deerfield Parkway
Buffalo Grove, IL 60089
+ 1 847-215-1000
Your feedback is important to us. If you have
comments about this document, please send them to
[e-mail]
Document No. 129-501
Printed in the USA
Page 2 of 2
Mounting Instructions (With Utility
Box QAA10X1.AASU) (Continued)
2. Push all wires back into the utility box.
3. Use the hex head Allen wrench to mount the
sensor assembly to the utility box with the two
security screws provided.
4. Connect the field wires to the appropriate
controller termination point. (See Wiring
Instructions.)
The installation is now complete.
Wiring Instructions
(QAA1011.AAX
U)
1. Connect the field wiring to the sensor lead wires
using the wire nuts provided. See Figure 2.
Figure 2. Wiring.
2. Connect the field wires to the appropriate
controller termination point. (See Wiring
Instructions).
NOTE: Some Siemens Building Technologies, Inc.
controllers may require a shield termination.
For individual panel wiring details, see the
appropriate hardware manual.
Wiring Instructions
(QAA1031.AAX
U)
1. If you are using pre-terminated cable, skip to
Step 3.
2. Using the room sensor connector tool, attach an
RJ-11 plug to both ends of the field cable. Align the
six wires in the same order on the connectors at both
ends of the cable. See Figure 3.
PIN Wire Color/Stripe
1 Green/white
2 Orange/white
3 Blue/white
4 White/blue
5 White/orange
6 White/green
Figure 3: Terminating the Sensor Cable
3. Route the field wiring cable between the
TEC and the 2 × 4-inch utility box or location
where the button sensor is to be mounted.
4. Insert the RJ-11 plug on the field wiring by
the TEC, into the RTS port.
5. Insert the RJ-11 plug on the field wiring by
the button sensor, into the sensor’s RJ-11
jack.