User Manual

List view
Viewing additional data points
6
A6V11211557_en
--_f 41 | 64
6.2 Viewing additional data points
In order to maximize the number of devices that can be monitored, only a select group of data points is
integrated to Desigo Control Point. Data points that are not displayed in the
List view can be accessed
through the generic data point list in the Setup & Service Assistant without being integrated to Desigo Control
Point.
For user roles with the appropriate access, do the following to access data points through the generic data point
list:
1. From any core function (for example, List view or Alarms), select > Setup & service.
 Additional data points at the same location in the hierarchy are displayed.
The navigation for each system depends on the devices being used. The data
displayed on your system may look different than what is shown in this manual.
Desigo primary and room controllers
● When navigating from Desigo Control Point to SSA:
– The same node is displayed in the SSA Application view if there is an exact match in the hierarchy.
– The last found hierarchy in the path is displayed if there is not an exact match.
– The root of the Application view is displayed if there is no match in the path.
● When navigating from SSA to Desigo Control Point the last selected node is displayed.
Figure 9: Navigating to SSA from the building hierarchy.