Environmental Declaration

EPD - Type II
Based on ISO 14021
Building Parts
PA/CuZn/Fe Terminal block 11 pole (2 pieces) 38g
FR4; TBBA; solder SnAgCu Main-Board PCBA variant
FR4; TBBA; solder SnAgCu Processor-Board PCBA 10g
*Variant parts list
[g]
Total weight of device
Upper housing
Terminal block 2 pole (1 piece)
Terminal block 3 pole (5 pieces)
Terminal block 3 pole (6 pieces)
Terminal block 3 pole (7 pieces)
Main-Board PCBA
Fire load [MJ]
Typical energy consumption
[kWh/a]
Comments
A5W00061374 AB 06.11.2020
97
PXC4.E16S
462
96
PXC4.M16S
465
PXC4.E16
483
95
34
4
174
212
11
28
200
155
39
10
206
162
PXC4.M16
485
97
4
11 10
195
34
142
EU-directive 2011/65/EU (RoHS)
The device does not contain substances in concentrations and applications banned under the EU RoHS Directive, including the 4 phthalates added to Annex
II in 2015.
To the best of our knowledge and according to the information of our suppliers the above mentioned device and its packaging contain no substances of the
candidate list according to Article 59 (1, 10) of the regulation (EC) No. 1907/2006 concerning the Registration, Evaluation, Authorisation and Restriction of
Chemicals (REACH) in concentrations above 0.1 % w/w. Contained REACH candidate substances, which will become known at a later date, are listed on the
delivery note.
(Status according to the creation date of this document.)
Please contact your local Siemens branch office to get further information on environmental aspects and disposal.
Legal Disclaimer: This declaration is for information purpose only.
Siemens Schweiz AG therefore does not assume liability for any error or for any consequences which may arise from the use of this information to the maximum extent under
the law.
This Environmental Product Declaration does not constitute a guarantee of the composition of a product, neither does it guarantee that the product will retain a particular
composition for a particular period.
Regulation (EC) No. 1907/2006 (REACH)
The device is low-halogen with exception of:
PCB (TBBA)
The device is classified as waste electronic equipment in terms of the European Directive 2012/19/EU (WEEE) and must
not be disposed of as unsorted municipal waste. Regarding disposal, use the systems setup for collecting electronic waste.
Observe all local and applicable laws.
Disposal
PCBAs (Printed Circuit Board
assembled)
Restricted Page 2/2