Data Sheet for Product

5 / 12
Siemens PXC3.E... Room automation stations CM1N9203en_08
Smart Infrastructure 2020-10-30
LED indicators
(depending on the type)
9203z02
RUN
FLT
IB
PL
DALI
SRV
1)
2)
1) Service pin
2) Service pin DALI
9270Z05
8 7 6 5 4 3 2 1
LED
Color
Activity
Function
RUN Green Continuously ON
Continuously OFF
Flashing
Device ready to operate.
No supply for device.
Start-up or program halted
FLT Red Continuously OFF
Continuously ON
Rapid flashing
OK
HW or SW error.
Wrong or corrupted application.
IB Yellow Continuously ON
Flashing
Continuously OFF
OK.
Island bus communication.
No modules connected
TX-I/O modules not configured or
communication fault.
PL Yellow Continuously ON
Flashing
Continuously OFF
OK.
KNX PL-Link communication.
KNX PL-Link not used or communication
fault.
DALI Yellow Continuously ON
Continuously OFF
Flashing
Blinking per
IDENTIFY DEVICE
command
OK
DALI not used or communication fault.
DALI bus communication
DALI-2 only: Physical identification of the
room automation station (5 Hz for 10 s)
SVC Red Continuously OFF
Blinking
Blinking per wink
command*)
OK.
No application loaded.
Physical identification of the room
automation station.
Ether-
net
1 / 2
Green Continuously ON
Continuously OFF
Flashing
Link active
Link inactive
Network activity
Yellow Continuously ON
Continuously OFF
Link 100 Mbps
Link 10 Mbps
*) Wink command
pattern:
2s
1s
21s
5 Hz 5 Hz
9222z02
2s
1s
Service pins
Pin
Action
Description
(depending on the type) 1) Short press Ethernet Physical identification of the room automation
station in the network.
2) Short press DALI test: All ballasts On or Off
Stops sending the DALI-2 IDENTIFY DEVICE
commands
Long press
> 4 s
DALI test: Start / stop the following function:
All ballasts blink (2 s On, 2 s Off).
Sends continuously DALI-2 IDENTIFY DEVICE
commands. The identify behavior of the devices
is vendor specific (e.g. LED blinking, buzzer)