Operating Instructions
Table Of Contents
- Cyber security disclaimer
- How to Use This Manual
- Chapter 1—Introduction
- Chapter 2—Hardware Features
- 16- and 24-Point Compact Series Diagram
- 36-Point Compact Series Product Diagram
- Supported Point Types
- Compact Series Backup Batteries
- Memory
- Communication Connections
- Compact Series Specifications
- BACnet Compact Series Specifications
- Compact Series Smoke Control Application Requirements
- HOA (Hand-Off-Auto) Upgrade Kits
- PXC Compact on P1
- PXM10S/T Product Overview and Description
- Unitary Equipment Controller
- TX-I/O Product Range Overview
- PX Series Enclosures and Service Boxes
- Chapter 3—Applications
- Chapter 4—Troubleshooting
- Glossary
- Index
Chapter 2—Hardware Features
PXC Compact on P1
0
76
| 118
Siemens Industry, Inc.
Owner's Manual
553-104
Building Technologies
2018-10-01
Menu/Submenu
Step
Description
Edit Pt Monitor
Rotate
DIAL
to select desired
point.
Displays all available points and subpoints at the field
panel.
Subpoints Rotate
DIAL
to select subpoint.
Displays a list of subpoints associated with the selected
point.
Press
DIAL
/
OK
to select
Y
or
N
.
Y=Yes; point is monitored.
N=No; point is not monitored. (This is the default setting.)
Press
ESC
. Returns you to the Point Monitor menu.
Resetting Point Monitor
Do the following to reset points in the Point Monitor.
Figure 29: Reset Submenu
Menu/Submenu
Step
Description
Main
Rotate
DIAL
to highlight
Point
Monitor
.
Press
DIAL
/
OK
to select
Point
Monitor
.
Displays the Point Monitor menu.
Point Monitor Rotate
DIAL
to highlight
Reset
.
Press
DIAL
/
OK
to select
Reset
.
Displays the Remove Monitor submenu.
Remove Monitor Rotate
DIAL
to highlight point.
Press
DIAL
/
OK
to make select
point.
Remove Monitor
Are you sure?
Rotate
DIAL
to highlight
Yes
or
No
.
Confirms you want to remove a point(s) from being
monitored.
Press
DIAL
/
OK
to make
selection.
Press
ESC
. Returns you to the Monitor menu.
Figure 30: Remove Monitor Submenu