Installation Instructions

Document No. 565-1001
Installation Instructions
October 25, 2010
Information in this document is based on specifications believed correct at the time of publication. The right is reserved to make changes as
design improvements are introduced. APOGEE and Insight are registered trademarks of Siemens Industry, Inc. Other product or company
names mentioned herein may be the trademarks of their respective owners. © 2010 Siemens Industry, Inc.
Siemens Industry, Inc.
Building Technologies Division
1000 Deerfield Parkway
Buffalo Grove, IL 60089-4513
U.S.A
Your feedback is important to us. If you have
comments about this document, please send them
to [e-mail].
Document No. 565-1001
Printed in the USA
Page 2 of 2
NOTE:
Communication with the American Auto-
Matrix PUP devices can be unstable if
there are multiple American Auto-Matrix
PUP devices powered from the same
power supply
and if the wires are not
connected to the power terminals using
the same polarity.
Even though the American Auto-Matrix
PUP devices use AC power, the same
power wire must be connected to the AC
Common terminal on all American Auto-
Matrix PUP devices. If the AC power
wires are crossed, the American Auto-
Matrix PUP device will run, but may be
unable to communicate with the driver.
Connecting the American Auto-
Matrix PUP Driver to the
American Auto-Matrix Device
Follow these steps to connect the American Auto-
Matrix PUP Driver to the American Auto-Matrix
devices:
1. Make cables per the diagram in Figure 1.
2. Connect cables per the diagram in Figure 1.
DRIVER
+
-
S
+
-
+-S
American Auto-Matrix
PUP Devices
GX
DX
VAV
GC
MC
etc...
To Other
PUP Devices
GW1459R1
FLN
GND
Tape Back
Shield
Figure 1. Connecting the American Auto-Matrix PUP Driver to the American Auto-Matrix Device.