User Manual

3 / 10
Siemens PXC001 System controllers CM1N9223en_09
Smart Infrastructure 2020-05-30
Ordering
Product number
Stock number
Designation
PXC001.D
S55372-C113
System controllers ( BACnet/LonTalk)
PXC001-E.D
S55372-C114
System controllers (BACnet/IP)
PXA40-RS1
S55372-C115
Option module RS1
PXA40-RS2
S55372-C116
Option module RS2
Mechanical design
The compact construction enables the devices to be mounted on a standard
mounting rail.
1
Plastic housing
2a
2b
Front cover
PXM40-RS... option module
3
Plug-in screw terminal block (operating voltage)
4
Plug-in screw terminal block (LONWORKS bus, PXC001.D only)
5
Network interface RJ45 (BACnet / IP, PXC001-E.D only)
6
LED indicators for communication
7
LED indicators for device and system status
8
Service pin (Network identification)
9 *)
RJ45 Interface for PXM10, XWP and PX KNX-Tool (RJ45, PXC001.D only)
RJ45 interface for PXM20 (PXC001.D only)
10
Plug-in screw terminal block (RS485)
11
RS232 interface
12
Plug-in screw terminal block (KNX)
13
RJ45 interface (ETS tool for service use)
14
KNX programming pin
15 *)
RJ45 interface for PXM10, XWP and PX KNX-Tool (PXC001-E.D only)
RJ45 interface for PXM20 (PXC001.D only)
16
Slider for mounting on DIN rail
*) PX KNX does not support the PXM10.
PXA40-RS...
RX TX
SERVICE
RX TX
RS232/RS485
KNX
SERVICE
INFO
COMM
LOW BATT
FAULT
RUN
HMI/TOOL
HMI
5
4
CLB
CLA
1 2
3
6
7
8
RS485
RS232
9 10
CE -
SERVICE
KNX
TOOL
CE +
2b
9223z16
PXC001...