Installation Instructions

Document No. 553-130
Installation Instructions
August 31, 2013
Page 4 of 6 Siemens Industry, Inc.
7. Partially insert mounting bolts in holes.
8. Mount the enclosure to the wall. Check the
enclosure to be sure it is level.
9. Tighten the mounting bolts.
10. Drill the two lower mounting holes.
11. Insert and tighten the remaining mounting bolts.
12. Mount the door on the enclosure.
13. Connect the door grounding wire to the stud inside
the enclosure.
14. Run conduit and pull wires into the panel. Be sure
to leave enough wire for future changes or
additions, and to allow for full door swing
clearance (see Figure 6).
15. Label each wire.
16. Place the product layout sheet in the label pouch
inside the door.
The installation is now complete.
Figure 4. 19” PX Series Enclosure Dimensions.