Installation Instructions

Document No. 553-130
Installation Instructions
August 31, 2013
Page 2 of 6 Siemens Industry, Inc.
CAUTION:
Anchorage is not preapproved for Seismic
Certification and must be approved by the
Inspector of Record before installation.
Seismic Certification Preapproval requires:
 Installed Equipment is listed in OSP.
 Enclosures are non-isolated wall
mounted using four 1/4” minimum
diameter bolts.
 Enclosure assembly certification
includes enclosure with door, service
box, installed equipment and wiring.
 Total assembly weight not to exceed
50 lbs. for 19” enclosure assembly or
100 lbs. for 34” enclosure assembly.
 Center of gravity is located from origin
at enclosure lower left mounting hole
to 9 x 8 x 2 inches for 19” assembly or
10 x 16 x 2.5 inches for 34” assembly.
Variance due to installed components
is < 10%.
 DIN Rails mounted on backplane
using three supplied screws each.
 Listed equipment not capable of being
installed on DIN rails may be fastened
to the backplane with supplied screws.
 Listed communication devices may be
fastened to enclosure or backplane
and power packs to outlet with 3M
®
Dual Lock
®
Reclosable Fasteners
SJ3560 (Type 250). Use two pair for
devices and one pair for power packs.
Minimum 1” square per 2 lbs.
PXC0048R1
I
Figure 1. 19” PX Series Enclosure Assembly.
PXC0047R1
I
Figure 2. 34” PX Series Enclosure Assembly.