User Manual

+
T
Point Operation 55
---------------------------------------------------------------
Enter a parameter name, e.g.:
"OSV"
[OK]
or a parameter group:
"MAIN" (Main parameters)
"OPER" (Operating parameters)
"SERV" (Service parameters)
"CONF" (Configuration parameters).
[OK]
If the entered parameter or the group does not exist, the
following error message appears:
"Invalid Input"
Entering a parameter The parameter is appended at the end of the list. If the list
in Free mode: already contains 13 parameters, the parameter at the very
bottom of the list is replaced by the newly selected one.
Entering a parameter A jump is made to the page of successive parameters,
in Fixed mode: which then begins with the selected parameter.
If the parameter is already available on the screen, only
the marking jumps there.
Entering a A jump is made to the start of the entered parameter group
parameter group: and a change is made to the Fixed mode.
[Forward] Parameter display:
One parameter page forward and change to Fixed mode.
TRR display:
One page of TRR entries forward.
[Backward] Parameter display:
To the start of the group of main parameters and change
to Fixed mode.
TRR display:
Back to the first page of the TRR entries.
[TRR] Display of the Time Reaction Register.
[PAR] Jump from the display of the Time Reaction Register back
to the start of the parameter group "Main Parameters," and
change to Fixed mode.
---------------------------------------------------------------
CM2B8523E UNIGYR VISONIK Insight March 1995