User Manual

Insight in Brief 32
---------------------------------------------------------------
2.9 Macro keys
---------------------------------------------------------------
The keys of the numeric key pad listed below can be used
to start macros from the TXCM catalogue of the DCS.
The macro keys operate only in the "Dialogue" function.
In addition, two conditions must be fulfilled:
- The parameter TERX in the terminal point $Tn must
be set to "ITER&MaKB."
- The "NumLock" key must be pressed.
Key Macro number
in the TXCM Catalogue
<F2> 300
<F4> 301
<F5> 302
<F6> 303
<F7> 304
<F8> 305
<F9> 306
<F11> 307
<F12> 308
<Alt Shift F2> 309
<Alt Shift F4> 310
<Alt Shift F5> 311
<Alt Shift F6> 312
<Alt Shift F7> 313
<Alt Shift F8> 314
<Alt Shift F9> 315
<Alt Shift F10> 316
<Alt Shift F11> 317
<Alt Shift F12> 318
---------------------------------------------------------------
CM2B8523E UNIGYR VISONIK Insight March 1995