User Manual

Appendix:
Communication Configuration 244
---------------------------------------------------------------
The connection with the DCS is always made via a serial
port, optionally via a direct link or via a modem.
Only one connection is possible at any one time.
In order to secure a connection with the DCS, the correct
settings must be made both in the DCS and in "UNIGYR-
VISONIK Insight."
In the DCS, these are settings for the following points: (For
telephony, see "TIB 53" under "Teleterminal.")
$Tn: TERX, OPTO, BAUD, MCAT, DSEQ, DTYP
$nnn'CO: LSS, MCAT, DSEQ
$nnn'TY: OPTO, TERX
16.1 Configuring a direct connection
---------------------------------------------------------------
IMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM M;
Port configuration:
: :
"UNIGYR-VISONIK Insight" window
: :
Select "Communication"
: :
Select "Settings"
: :
➡ "Port" window : :
HMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM M<
8522OL0E
Select the desired port (e.g. "COM2").
[OK]
➡ "Communication Parameter: COM2" window
---------------------------------------------------------------
CM2B8523E UNIGYR VISONIK Insight March 1995