User Manual

Appendix:
Installation 235
---------------------------------------------------------------
14.7 Warning beep
---------------------------------------------------------------
IMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM M;
: :
"UNIGYR-VISONIK Insight" window
: :
Select "Options"
: :
Start "Warning Beep"
: :
➡ "Warning Beep" pop-up window:
: :
HMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM M<
8522O17E
Make the desired selection, then
[OK]
"Beep Level" defines the colour of incoming and outgoing
fault messages in the Message window, or when printing
with conjunction with the MPR parameter (see below).
"Beep Duration" influences the duration of the beep sig-
nal. This always sounds when communications arrive
(COMM function); for the other messages, only if the Mes-
sage window has been minimized.
Parameter MPR is Incoming fault: Red
higher or equal Outgoing fault: Green
to the "Beep Level":
Parameter MPR is Incoming fault: Blue
lower than Outgoing fault: Blue
the "Beep Level":
The effects are caused solely by entries in the "Warning
Beep" window, and not by the value of the parameter
"PIPT" in the corresponding V.24-Point ($Tn).
---------------------------------------------------------------
CM2B8523E UNIGYR VISONIK Insight March 1995