User Manual

N
Navigation 155
---------------------------------------------------------------
If, when Navigation is initiated, there are several points
marked in the Alarm function, the Navigation proceeds to
the last point which was marked.
The destination function "Trend Plot" is the exception. It
displays a maximum of the last ten marked points.
10.2 Initiating Navigation
---------------------------------------------------------------
IMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM M;
: :
"UNIGYR-VISONIK Insight" window
: :
Select "Navigation"
: :
Select "Destination Function"
: :
➡ Window of the Destination Function : :
HMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM M<
10.3 Destination Function
---------------------------------------------------------------
The results of the Navigation function in the various desti-
nation functions are described below.
Point Operation: A "Point Operation" window opens with the display of the
Navigation Point.
Alarm Operation: An "Alarm Operation" window opens. The selection is set
as follows:
- Address range limited to the Navigation Address
- All alarm statuses
- All priorities
Thus, after "Updating," the lines of the Navigation Point
are the only ones to appear in the alarm list.
Timeswitch A "Timeswitch Catalogue" window immediately opens with
Catalogue: the pop-up window "Load Timeswitch Catalogue from
DCS/SS."
The Navigation Address is the default in the input field
"Substation."
---------------------------------------------------------------
CM2B8523E UNIGYR VISONIK Insight March 1995