Installation Instructions
Table Of Contents
- Figure 1. MS/TP Point Pickup Module.
- Product Description
- Product Numbers
- Caution Notations
- Expected Installation Time
- Prerequisites
- Installation
- Figure 2. Back plate knockout holes.
- Figure 3. Removing the cover
- Figure 4. Removing the PCB.
- Figure 7. Routing I/O wiring.
- Figure 8. Power Wiring.
- Figure 9. FLN 2 wire network interface.
- Figure 10. FLN 3-wire interface.
- Figure 11. Wiring I/O to terminals.
- Figure 12. 6 Point Digital controller board.
- Figure 13. 6 Point Analog controller board
- (PPM-2U3322.BPF and PPM-2U3322.BPR)
- (PPM-3U63.BPR, for China only)
- Figure 14. 12 Point Combination controller board.
- Table 1. DIP Switch Settings for Baud Rate.
- Figure 15. Installing front cover to back plate.
- Figure 16. MSTP PPM Dimensions.
- I/O Configuration Diagrams
- Figure 17. AI/DI wiring for 6 point digital.
- Figure 18. DO wiring for wiring for 6 point digital.
- Figure 19. Analog input wiring.
- Figure 20. Universal input wiring.
- Figure 21. Analog output wiring.
Document No. 550-992
Installation Instructions
August 20, 2014
Siemens Industry, Inc. Page 5 of 6
13. Snap the front cover on. A POWER/RX LED
solid ON indicates that the unit is powered, but
no communication. A flashing LED indicates
that the unit successfully receiving packets on
the network.
Figure 15. Installing front cover to back plate.
14. Using the permanent marker or label maker,
record the physical point assignments, the
network number and MAC address on the label.
The installation is complete.
Figure 16. MSTP PPM Dimensions.
NOTE: The PPM may not fit in smaller junction boxes if using multiple or lower gauge wires. A larger junction box or
expansion box may be needed in these cases.