Installation Instructions
Table Of Contents
- Figure 1. MS/TP Point Pickup Module.
- Product Description
- Product Numbers
- Caution Notations
- Expected Installation Time
- Prerequisites
- Installation
- Figure 2. Back plate knockout holes.
- Figure 3. Removing the cover
- Figure 4. Removing the PCB.
- Figure 7. Routing I/O wiring.
- Figure 8. Power Wiring.
- Figure 9. FLN 2 wire network interface.
- Figure 10. FLN 3-wire interface.
- Figure 11. Wiring I/O to terminals.
- Figure 12. 6 Point Digital controller board.
- Figure 13. 6 Point Analog controller board
- (PPM-2U3322.BPF and PPM-2U3322.BPR)
- (PPM-3U63.BPR, for China only)
- Figure 14. 12 Point Combination controller board.
- Table 1. DIP Switch Settings for Baud Rate.
- Figure 15. Installing front cover to back plate.
- Figure 16. MSTP PPM Dimensions.
- I/O Configuration Diagrams
- Figure 17. AI/DI wiring for 6 point digital.
- Figure 18. DO wiring for wiring for 6 point digital.
- Figure 19. Analog input wiring.
- Figure 20. Universal input wiring.
- Figure 21. Analog output wiring.
Document No. 550-992
Installation Instructions
August 20, 2014
Siemens Industry, Inc. Page 3 of 6
Figure 5. Removing the DIN clip before mounting to a
flat surface.
6. Mount the back plate as appropriate. If
mounting to a DIN rail, pull the clips back so
that the DIN track is completely clear. Place the
unit on the DIN rail, then press both clips
inwards to lock.
Figure 6. Mounting to a DIN rail, electrical box or flat
surface.
7. Run the wiring through the knockout holes to
the terminals.
Figure 7. Routing I/O wiring.
8. Connect wiring to power and I/O terminals.
Figure 8. Power Wiring.
Figure 9. FLN 2 wire network interface.
Figure 10. FLN 3-wire interface.