Installation Instructions

ManualsBrandsSiemens ManualsBuilding automationMS/TP Point Pickup Module

Document No. 550-981

March 12, 2009

Point Pickup Module

Page 1 of 5

Figure 1. Point Pickup Module.

Product Description

The Siemens Point Pickup Module Controller is a

slave I/O device that communicates in P1 FLN. It is

designed to allow point expansion for other Siemens

controllers and reside on any APOGEE Siemens

Building Technologies control system.

Product Numbers

Point Pickup Module PPM-1U32.PPR

Accessories

Point Pickup Module DIN KIT PPM-DIN.KIT

See the Point Pickup Module DIN Kit Installation

Instruction (550-990).

Warning/Caution Notations

WARNING:

Personal injury/loss of life may

occur if you do not follow the

procedures as specified.

CAUTION:

Equipment damage, or loss of

data may occur if you do not

follow the procedures as

specified.

Required Tools

Small Flat-blade screwdriver

Cordless drill/driver set

Expected Installation Time

15 minutes

Prerequisites

Wiring conforms to NEC and local codes

and regulations. For more information, refer

to the Wiring Guidelines manual (125-3002).

24 Vac Class II power source available.

Supply power to the controller is OFF.

Any application specific hardware or devices

installed.

Figure 2. PPM assembly with 4"x4" electrical box.

Summary of content (5 pages)

PAGE 1
Installation Instructions Document No. 550-981 March 12, 2009 Point Pickup Module Expected Installation Time 15 minutes Prerequisites Wiring conforms to NEC and local codes and regulations. For more information, refer to the Wiring Guidelines manual (125-3002). 24 Vac Class II power source available. Figure 1. Point Pickup Module. Product Description Supply power to the controller is OFF. Any application specific hardware or devices installed.
PAGE 2
Document No. 550-981 Installation Instructions March 12, 2009 Installation 1. Disconnect power. 2. Install barrier onto backplate. 4. Connect wiring to power and I/O terminals. Figure 5. Power Wiring. Figure 6. FLN Wiring. Figure 3. Installing the barrier. 3. Run wiring up through backplate to terminals. Figure 4. Routing I/O wiring. Figure 7. Wiring I/O to terminals. Page 2 of 5 Siemens Building Technologies, Inc.
PAGE 3
Document No. 550-981 Installation Instructions March 12, 2009 5. Mount backplate to electrical box. 9. Snap front cover on. Figure 10. Installing Front cover to back plate. Table 1. Logical Point Descriptions. Figure 8. Mounting Back plate to electrical box. 6. Set address using DIP Switches. Binary 0 to 255 from positions 1 through 8. Example 1: Switch 1 and 2 ON = Address 3. Example 2: Switch 1 and 4 ON = Address 9.
PAGE 4
Document No. 550-981 Installation Instructions March 12, 2009 Figure 12. PPM Dimensions. The PPM may not fit in smaller junction boxes if using multiple or lower gauge wires. A larger junction box or expansion box may be needed in these cases. Page 4 of 5 Siemens Building Technologies, Inc.
PAGE 5
Document No. 550-981 Installation Instructions March 12, 2009 Wiring Diagrams Figure 14. DO Wiring. Figure 13. AI/DI Wiring. Figure 15. PPM Wiring Diagram. Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and models as design improvements are introduced. Other product or company names mentioned herein may be the trademarks of their respective owners. © 2009 Siemens Building Technologies, Inc.